Stiga MULTICLIP 8211-0223-07 Manuel d'utilisateur télécharger pdf (Page 6)

ENGLISH

Tecumseh: Stand the lawnmower on a level sur-

face. Clean the area round the oil plug, then re-

move the plug (fig. 8). If the oil is not level with the

edge of the hole, carefully pour in clean oil. Re-

place the oil plug.

FILL UP THE PETROL TANK

Fill with petrol before starting the mo-

tor. Never remove the filler cap or fill

with petrol while the motor is running

or still warm.

Never fill the fuel tank completely full

but allow a little room for the petrol to

expand.

Always use pure unleaded petrol. You must never

use 2-stroke petrol mixed with oil.

Note that you should always remember that petrol

is a perishable commodity. Never buy more petrol

than what you can use up in 30 days.

STARTING THE ENGINE

(Briggs & Stratton, Tecumseh)

1. Place the lawn mower on flat, firm ground. Do

notstartinhighgrass.

2. Make sure the spark plug lead is connected to

the spark plug.

3. If the lawnmower is equipped with a throttle le-

ver, set throttle lever B in full throttle position

(fig. 9).

4. When starting a cold engine: Press down the

primer fully three times (fig. 10, 11).

When starting a warm engine the primer does

not need to be used. If the engine stops due to a

lack of petrol, refill and press down the primer

three times.

5. Press in the Start/Stop-loop G against the steer-

ing. Note that the Start/Stop loop G must be

kept pressed-in to prevent the engine from stop-

ping (fig. 9).

6. Grasp the starter handle and start the engine by

pulling briskly on the starter handle.

7. To achieve the best cutting results, you should

always run the engine at full-speed.

Keep hands and feet well away from the

rotating blade(s). Never put your hand

or foot under the blade casing or in the

grass evacuation unit while the motor is

running.

STARTING THE ENGINE (Honda)

1. Place the lawn mower on flat, firm ground. Do

not start in high grass.

2. Make sure the spark plug lead is connected to

the spark plug.

3. Open the fuel cock (fig. 12).

4. Move the throttle control B to the chokeposition

. Note! Don't use the choke position when the

engine is warm (fig. 9).

5. Press in the Start/Stop-loop G against the steer-

ing. Note that the Start/Stop loop G must be

kept pressed-in to prevent the engine from stop-

ping (fig. 9).

6. Grasp the starter handle and start the engine by

pulling briskly on the starter handle.

7. When the motor starts, move the throttle lever

backwards until the max. rotation speed is ob-

tained. Note! The engine should always be run

at the maximum rotation speed to avoid abnor-

mal engine vibrations.

Keep hands and feet well away from the

rotating blade(s). Never put your hand

or foot under the blade casing or in the

grass evacuation unit while the motor is

running.

STOP OF ENGINE

Themotormaybeverywarmimmedi-

ately after it is shut off. Do not touch the

silencer, cylinder or cooling flanges as it

can cause burns and injury.

1. Release Start/Stop-loop G to stop theengine.

This loop must not be disengaged(e.g. through

fixing it in the depressed position against the

steering), as the engine cannot be stopped.

Honda: Close the fuel cock.

2. If the lawn mower is left unattended to,remove

the lead from the spark plug.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Stiga MULTICLIP 8211-0223-07 Manuel d'utilisateur Page 6

Commentaires sur ces manuels